This shows you the differences between two versions of the page.
rhino:jbbooleanfix [2014/11/18] |
rhino:jbbooleanfix [2020/08/14] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | |||
+ | ====== Fixing Boolean Problems ====== | ||
+ | |||
+ | ---- | ||
+ | Here's what I do when someone sends in a Boolean problem. -JB McNeel Tech support | ||
+ | |||
+ | First I check the Units and tolerance setting compared with the geometry in the file to make sure there isn't a major scaling problem. | ||
+ | |||
+ | Next is to run SelBadObjects and make sure there are no problems with the curves or surfaces. | ||
+ | |||
+ | After that I run the Intersect command between the two solids and see if I get closed curves that clearly define the trimming and joining boundaries. | ||
+ | |||
+ | That's the process. | ||
+ | |||
+ | If any of this is confusing, read on. The information and detail on the following pages is excellent. | ||
+ | |||
+ | |||
+ | |||
+ | |||