This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
rhino:reverseengineering [2021/11/02] joachim old revision restored (2021/09/09) |
rhino:reverseengineering [2023/02/10] (current) joachim |
||
---|---|---|---|
Line 1: | Line 1: | ||
======Reverse Engineering====== | ======Reverse Engineering====== | ||
+ | =====Rhinoceros 8===== | ||
+ | |||
+ | Reverse Engineering is the process of transforming a [[https:// | ||
+ | |||
+ | Rhino is **not** a reverse engineering program, since there are many aspects and tools needed to do reverse engineering. However, depending on your requirements, | ||
+ | |||
+ | Rhino 8 improves this process a step further than Rhino 7 by adding the [[https:// | ||
+ | Here are some resources on ShrinkWrap: | ||
+ | * https:// | ||
+ | * https:// | ||
+ | * https:// | ||
+ | |||
+ | The set of tools in Rhino 8 that can help convert a scan into an editable part are: | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | |||
+ | You'll find a growing colleection of tutorials on our [[https:// | ||
+ | |||
+ | |||
=====Rhinoceros 7===== | =====Rhinoceros 7===== | ||
This is a old, but still valid explanation of a [[https:// | This is a old, but still valid explanation of a [[https:// | ||
Line 21: | Line 43: | ||
You can extract section curves from a point cloud (PointCloudSection command), or from a polygon mesh with Section or Contour. | You can extract section curves from a point cloud (PointCloudSection command), or from a polygon mesh with Section or Contour. | ||
- | *[[http://download.rhino3d.com/ | + | *[[https://www.rhino3d.com/ |
There are also some plug-ins available which help the reverse engineering process. | There are also some plug-ins available which help the reverse engineering process. | ||
Line 34: | Line 56: | ||
- | *And there is also [[http://www.geomagic.com/en/ | + | *And there is also [[https://oqton.com/geomagic-designx/ |
---- | ---- | ||
Line 46: | Line 68: | ||
---- | ---- | ||
- | This [[http://download.rhino3d.com:80/download.asp?id=ScanCleanupRemodel|PDF file]] describes the process of cleaning up a scanned mesh and making it ready for STL printing. Additionally, | + | This [[https://www.rhino3d.com/ |
Add your comments... | Add your comments... |