Differences

This shows you the differences between two versions of the page.

--- rhino:foursrfreverse [2016/06/14]
+++ rhino:foursrfreverse [2020/08/14] (current)
@@ Line 1: / Line 1: @@
+====== Mitch's First Fillet Problem ======
+> **Summary:** //Here's an example sent in by Mitch Heynick.  Mitch writes: Fillet all vertical edges and the base with a radius of 10.  Fillet the horizontal inside ones near the top at 5. --Mitch//
+**Note:** V5 FilletEdge handles this correctly if all the edges are filleted at once.
+=====Mitch's First Fillet Problem=====
+\\
+| {{:legacy:en:Mitch1_01.jpg}} | Original polysurface. |
+\\
+| {{:legacy:en:Mitch1_02.jpg}} | Use ExtractSrf and Join to separate the top and the base.  Use FilletEdge (R=10) to fillet all of the desired edges.  Then Explode everything. |
+\\
+| {{:legacy:en:Mitch1_03.jpg}}  | Use FilletSrf (R=5, Extend=Yes, Trim=Yes) to fillet the vertical side surfaces of the top and base (Black). |
+\\
+| {{:legacy:en:Mitch1_04.jpg}}  | Use FilletSrf (R=10) and fillet the 5mm surfaces made in the previous step. |
+\\
+| {{:legacy:en:Mitch1_05.jpg}}  | Untrim the vertical corner fillet surfaces, then Trim them with the edges of the small corner fillet surface made in the previous step. |
+\\
+| {{:legacy:en:Mitch1_06.jpg}}  | Repeat this process on each corner and join into a closed solid. |
+\\

McNeel Wiki