Download here It requires an OpenVR compatible VR headset.

With this option you only need the “Red & Blue” glasses. It does not require any special hardware, just the glasses which are available anywhere and are very inexpensive.

Both the Anaglyph and 3D Stereo plugins look and act the same…they both can be installed, but it’s hard to distinguish between the two. If you don’t need both, then you probably should not install both.

QuadBuffering probably needs to be OFF if/when using Anaglyph stereo. This is controlled by the TestQuadBuffering command. It is off by default. But you may need to toggle it on and they off again to verify the setting.

Anaglyph stereo renders multiple frames itself. Adjust camera position and viewpoint with the Rhino UI.

Anaglyph plugin shows up in the panels as “Stereo View” while Active/Passive plugin shows up as “Stereo 3D View”.

1. Download the plugin StereoView.rhp

2. Open Rhino.

3. Drop StereoView.rhp on to the open Rhino application.

4. In the Show Panels popup, check “Stereo View” to open the panel.

See discussion on Rhino Support Forum here.

Windows Rhino 7 & 8 now supports “Quad Buffering” which is what is needed for Passive/Active stereo viewing.

The Quad Buffering support in V8 is for hardware like PluraVision 3D and passive stereo viewing from people like Schneider Digital.

Typically laptops do not support any kind of stereo viewing. But you will need to test.

Note: Close Rhino. You must get the computer all setup for stereo viewing prior to starting Rhino

Quad Buffering does this need to be turned on in Rhino 8 and requires you enable “3D mode” in Windows display settings, as well as the GPU manufacturer's control panel.

GPU control panel should have some kind of Stereo option.

Here is the nvidia Control Panel option.

Check is the NVIdia control panel and see if there are Stereo options shown above.

Note: You will not be able to enable it from there since this is now a Windows settings. Notice in my screenshot of NVidia's control panel it says “Enabled” but it's grayed out. This is because “3D display mode” was already enabled in the Windows→Display settings dialog.

1. Download the plugin Stereo3DView

2. Open Rhino.

3. Drop on to the open Rhino application

4. Show Panels“ popup, check “Stereo 3D View”

In Rhino, turn on QuadBuffering with the TestQuadBuffering command.

• You need very specific hardware and glasses.
• You need a monitor with a fast refresh rate.
• You need special glasses.

If you have an “Active” stereo configuration, then your glasses have to be able to sync with the monitors refresh (to flicker between left and right lenses), which means that the glasses either plugin somewhere in the back of the GPU, or there is some kind of USB receiver that plugs into the computer and the glasses communicate with it.

If you have a “Passive” configuration (the kind that 3D movies in theaters use), then you need also need special monitors, but the glasses are simply polarized lenses.

In either case, you also need to make sure that the GPU control panel is configured for the type of mode your hardware supports.

For ”Active“ stereo you should be able to use Generic active stereo setting. For ”Passive“ stereo, you need to use Clone mode or Planar stereo mirror display. Passive modes usually require some kind of dual displays with a plane of glass that sits at an angle between them.

This is a passive mode setup by Schneider Digital called the “3D PluraView”.

Because Rhino provided a type of “Stereo mode” setting in Rhino 5. you can not access this by simply “just turning it on”. This is not the case and there will be a lot a experimentation required if you want to use this.Support is availble on the Rhino Support Forum.